Nitro DCM-01 Mobile Diesel Particulate Filter Cleaning Machine

Thanks to the Nitro DCM-01 Mobile Diesel Particulate Filter Cleaning Machine, you can easily clean the DPF in Euro 5 and Euro 6 vehicles, without the need to disassemble the DPF.

With Nitro DCM-01, you can easily clean the soot and dirt accumulated in the Diesel Particulate Filter located at the exhaust outlets of the vehicles, through the oxygen and differential pressure sensors in the vehicles.

Thanks to Nitro DCM-01 working with special hydrogen-based cleaning liquid, water and regeneration, cleaning can be done on the vehicle within half an hour without the need to disassemble the DPFs.

NM-DCM-01 easily dissolves wastes such as soot and oil accumulated in the DPF and Catalytic Converter, thanks to the special hydrogen-based cleaning fluid it contains, and throws these wastes out through the exhaust system with the help of water.

This cleaning process never harms the DPF and Catalytic converter and the machine is very environmentally friendly.

What are the advantages of NM-DCM-01 Mobile Diesel Particulate Filter Cleaning Machine compared to other machines?

1- Possibility of cleaning on the vehicle: DPF cleaning will be very easy as it will be done without the need to disassemble the DPF. If the cleaning process is not successful, the DPF should be removed from the vehicle and cleaned.

2-It saves you time: You will save a lot of time compared to other machines as you will not need to remove the Diesel Particulate Filter from the vehicle.

3-Price is quite successful in terms of performance: NM-DCM-01 Mobile Diesel Particulate Cleaning Machine is cheaper than other machines.

4-It provides convenience in your service: Thanks to the Mobile Particulate Cleaning Machine, you can handle the vehicles coming to your service in your own service without sending them outside.

Usage Instruction:

1- Before starting the cleaning process, make sure that the engine is cold.

2- Use protective equipment such as gloves and glasses during the procedure.

3-You need to connect the connectors to the sensor places.

4- While the engine is idling, press the Hydrogen button, after doing this, the vehicle DPF cleaning fluid will be given automatically.

5- After the cleaning process starts, it will automatically finish in 30 minutes, after the process is finished, the engine should be left idling for 3 minutes.

6-Then, water will be applied. During this process, the vehicle must be throttled to operate at 2500 rpm.

7-After the cleaning process is finished, you need to install the sensors and perform DPF regeneration and DPF reset operations with the help of a diagnostic device. Otherwise, the DPF lamp on the indicator will not go out.