WHAT IS MAGİCMOTORSPORT FLEX BRAIN (ECU) SOFTWARE READING DEVICE?
The Flex device is the new product of the magicmotorsport company that has replaced the x17 device and is now planning to publish all updates on this device.
Flex device consists of two parts and cables. With this device, which is divided into two as flex and flex box, we can shoot the engine ecu (ecu), flash and eprom, if necessary, all the software in the ecu (ecu).
The magicmotorsport company, which does not find it sufficient to process the engine ecu , allows us to do the transmission card reading and tcu cloning with the same device.
It allows you to read and write easily with its advanced diagram images and easy connections.
WHAT IS BRAIN (ECU) SOFTWARE?
It contains software in the ecu (ecu). By playing with this software, desired operations can be performed on the vehicle.
ecu cloning, chiptuning, fault code shutdown (dtc off) etc. You can do many operations like.
HOW TO CONNECT THE FLEX DEVICE?
The Flex device has three types of connections. Connection with obd, connection with pin ends and connection by booting.
HOW TO CONNECT AND READ WITH FLEX OBD?
There are two obd cables in the Flex device box. Green wire and red wire. When you enter the program of the flex device which cable you should use, it shows you which of these cables you should use in the diagram part.
By connecting the cable it shows to the vehicle, you turn on the ignition and act according to the instructions given by the flex program. With the Flex device, the reading process begins in this way.
HOW TO READ PIN WITH FLEX DEVICE?
We connect flex devices (flex and flexbox) to each other. We take the pin cables out of the box and open the flex program.
We select the ecu that we will connect from within the program and attach the cables to the flex device and the ecu pin ends according to the connection scheme, then continue the reading process according to the instructions given by the device and the program.
HOW TO MAKE READING BY THROWING BOOT WITH FLEX DEVICE?
We connect the Flex devices to each other according to the scheme as in the pinout connection. We open the back cover of the ecu (ecu) and we solder our cable wherever it asks us to throw the boot cable (purple cable).
If there are resistances in the connection, we also put resistance to the legs where the resistance throws and we follow the instructions given.
Our reading process is so much that you can easily use the flex device with a very simple program.
Benzer Ürünleri İncelemek İçin Tıklayınız